Zenith DVB318, Руководство по обслуживанию

Страница: 12 / 68

3-3
IC901
Front
µ
-com
IC601
FLI2301 IC603
Sil170B
IC501
MPEG IC503
Flash
ROM
X501(27Mhz)
D-Reset M-Reset
X601(13.5Mhz)
M-Reset WE
data
address
1) MPEG IC start oscilating(27Mhz) after being
installed VCC
2) MPEG IC & FLI2301is initialized by /
M - RESE T
3) MPEG IC send the WE(read/write) signal before
communicating with FLASH ROM
WE signal should be confirmed by Flash or the
next step will not continue.
As that result, the initial step(power cord in ->
green LED -> off -> standby) will fail.
If WE signal doesn’t appear, check the VCC and
replace the Flash ROM…
If WE signal doesn’t appear, check the VCC and replace the Flash ROM…
M-reset
D-reset
X-601 clk
3. Initializing between MPEG(FLI2301B) and Flash
4. Sil170B is nitialized by M-Reset and D-Reset
VCC (3.3V)
V-REFD (2.1V)
9 PIN
10 PIN
IC202
DSP
(STL6316)
1) There is one kinds of reference voltage on DSP
IC
2) These are outputed from DSP IC and 2.1V is
used as reference of Pick - up
If these reference voltage don’t appear, All kinds of
servo control will fail.
So, should be checked first of all Check the DSP
IC and replace…
3) The reference voltage of DSP is 1.65V for inside
of IC L6316, but we can cheek the voltage only
by TP.
TP211 is for tracking error and TP212 is for focus-
ing error.
VCC
3.3V
2.1V
Power
Cord in
VREF2
5. Reference Voltage 1