Zenith Concierge H20D35DT, Инструкция по установке и эксплуатации, Гарантия

Страница: 8 / 48

206-3489-O
P A G E 8
Cable Service (CATV) Hook Up
If you’re using a cable box, leave the TV on channel 3
or 4 and use your cable box to change channels.
If you’re using a cable box, Auto Program might only
find the channel your cable service is on (usually
channel 3 or 4). Don’t worry, that’s all you need!
Cable TV
Wall Jack
RF Coaxial Wire
(75 ohm)
TV Back
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
ANTENNA
CABLE
M.P.I.
Cable TV
Wall Jack
Cable Box
In
Out
RF Coaxial Wire
(75 ohm)
3 4
output
switch
TV Back
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
ANTENNA
CABLE
M.P.I.
Locate the Antenna/Cable jack on the back of
the TV.
Connect the cable service wire that runs from
the wall, according to one of the diagrams to
the right.
Remove the back of the remote and put in two
AA batteries.
Plug in the TV. Do not plug it into a switched
outlet. Your TV is designed to operate on stan-
dard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC power.
Go to page 12 to Auto Program the TV.
back of
remote
1
2
3
4
5
Connect cable service to the TV