Zenith Concierge H20D35DT, Инструкция по установке и эксплуатации, Гарантия

Страница: 7 / 48

Locate the Antenna/Cable jack on the back of the TV.
Connect the antenna wire, according to one of the
diagrams to the right.
Remove the back of the remote and put in two AA
batteries.
Plug in the TV. Do not plug it into a switched outlet.
The TV is designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to operate it on
DC power.
Go to page 12 to Auto Program the TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
206-3489-O
P A G E 7
Antenna Hook Up
Connect an off-air antenna to the TV
If you have a 75 ohm RF cable, then you don’t need any
adapters!
A 300 to 75 ohm adapter is not included with the Zenith TV.
300 TO 75 OHM
ADAPTER
TV Back
TV Back Connections Panel
(Expanded View)
RF Coaxial Wire
(75 ohm)
Antenna
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
ANTENNA
CABLE
M.P.I.
back of
remote
1
2
3
4
5
ANTENNA
CABLE
M.P.I.
TV Back
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV Back Connections Panel
(Expanded View)
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN