35
User Manual
8300 MkII Sound Reception System
5.9.5 Additional Options
The
Additional options
page contains configuration options that do not fall under any of the other categories.
To adjust any of these options:
1. Select the applicable option.
2. Enter the applicable information.
3. Click the
Save settings
button.
Options:
Description:
Detection direction:
Fore
This is the default setting. If
Fore
is selected, horns detected to the fore of
the microphone unit will be displayed at the fore of the display unit.
Detection direction:
Aft
If
Aft
is selected, all horns detected will be offset by 180˚ in the display
unit. Horns detected to the fore of the microphone unit, will be displayed
at the aft of the display unit.
Master
This is the default setting. The master unit must be connected to the
microphone unit. The master unit will transmit all detected signals to any
slave units over Ethernet.
Slave
The slave unit can not be connected to the microphone unit, but will
receive detections and sound from the master unit over Ethernet. There
may be multiple slave units in an installation.
Alignment offset
Use this setting to add an offset to all detections in case the microphone
unit has not been mounted accurately in the fore direction.
Pointer hold
Use this setting to adjust the length of time a detection is displayed after
the detection has ended. The default value is 7 seconds.
IMPORTANT:
When working with a master or slave setup, all units must be:
•
Connected to the same network.
•
Configured with different IP addresses.
•
Use the same transmission group.
NOTE:
You can view more information about the options by clicking on the (?) question mark buttons next to the
individual options.
The Additional options page also offers the possibility to do the following maintenance:
•
Firmware updates
•
Restore the unit to the factory defaults
•
Reboot the system
To complete any of the additional maintenance options:
•
To complete a Firmware update, click
Update firmware
•
To restore the factory defaults, click
Factory reset
•
To reboot the system, click
Reboot
