Zener 8000-V, Руководство по установке

Страница: 44 / 70

ZENER 8000-V Installation Manual _
38 IM00165
Setup Guide
Features Single direction operation, Select between local (console) and Remote (wiring to
terminal strip) control
Procedure
STEP 1. Complete the power wiring according to the instructions on pages 11 to 23
STEP 2. Choose your own control method from one of the following. Connect your control wiring as shown.
i
Local / Remote Selection
The Local/Remote Selection can be used in
conjunction with any of the above circuits. Wire
terminals 5 and 6 as shown.
In “local”, stopping and starting is controlled from
the front panel console. In “remote”, stop / start is
controlled from the terminal strip. The source of the
speed reference in both modes may be
independently configured to come from a wide
variety of sources including the terminal strip,
console up/down buttons, preset values and the
output of optional features such as the PID
controller and networked communications.
Start
Stop/
Reset
+5V
1
D1
2
D2
3
D3
4
D4
5
EN
6
Control Board Terminals
+5V
1
D1
2
D2
3
D3
4
D4
5
EN
6
Control Board Terminals
Run
Stop/
Reset
+5V
1
D1
2
D2
3
D3
4
D4
5
EN
6
Control Board Terminals
+5V
1
D1
2
D2
3
D3
4
D4
5
EN
6
Control Board Terminals
Local Remote
Switch or contact control
(2 – wire control)
Power up start
Drive will start as soon as
power is applied
Push button control
(3 – wire control)