ZENEC ZE-MR902-DVD, Инструкция по эксплуатации

Страница: 33 / 48

33
ENGLISH
10. Reconnect the terminal to the battery.

NOTES:
■
Do remember to connect the red wire to the ACC of the ignition switch. Otherwise the
battery charge might be drained off prematurely.
■
If the fuse is opened, first make sure that the cables have not caused a short circuit, and
then replace the old fuse with a new one of the same ratings.
■
Do not have unconnected cables or terminals touch the metal on the car or any other
conducting material.
■
To prevent short circuits, do not remove the caps from unused terminals or from the
ends of the unconnected cables.
■
After the display unit is installed, check and make sure the brake lights, blinkers, wiper,
etc. on the vehicle are working properly.
■
Insulate unconnected wires with vinyl tape or other similar material.
9.Attach the DVD player to the metal mounting plate using the CM 4x8 screws.
10.Reconnect the terminal of the battery.
Notes:
Do remember to connect the red wire to the ACC of the ignition switch. Or the
battery charge might be drained off prematurely.
If the fuse is opened, first make sure that the cables have not caused a short
circuit, and then replace the old fuse with a new one of the same ratings.
Do not have unconnected cables or terminals touch the metal on the car or
any other conducting material.
To prevent short circuits, do not remove the caps from unused terminals or
from the ends of the unconnected cables.
After the display unit is installed, check and make sure the brake lights,
blinkers, wiper, etc. on the vehicle are working properly.
Insulate unconnected wires with vinyl tape or other similar material.
Four CM4*8 screws
13
Four CM4*8 screws
ZE-MR902-DVD Manual D+E.indd 33 13.09.2006 14:34:31 Uhr