4
the generator to its normal operating speed to allow the cooling fan to remove most excess
moisture from inside the case. If available, compressed air can be used to good advantage
at this time to assist in the process of “drying” the generator.
4) After
Operating
in
Wet
Conditions
Excess water should be removed from the Welding Power Generator by operating the
vehicle’s engine briefly to allow the cooling fan to remove most excess moisture from
inside the case. Excess water can be removed from the Control Handle’s internal
components by simply hanging the Control Handle so that its electrode holder points
“down”. Moisture trapped in the handle or its components will drain out or evaporate.
D. DO
NOT…
!
use spray lubricants of any sort on any component; or
!
operate the unit in very dusty and or dirty conditions without insuring that cooling air
reaching the unit is as dust and/or contaminant free as possible; or
!
allow antifreeze compounds to contact system components without cleaning the
affected component with fresh water; or
!
allow accumulations of grease and/or dirt to form on system components; or
!
apply any sort of paint to any system component; or
!
clean system components with aerosol brake cleaners, carburetor cleaners, spray
degreasers, or other chemicals except as noted above in “Cleaning” above.
Содержание 150 series
Страница 4: ......
