Zelmer ZZS7042SE, Руководство пользователя

Страница: 124 / 128

124
ZW-003_v03
CONNECTING OUTFLOW HOSES
Insert the outflow hose into the channeling pipe of 4 cm min. in diameter or insert it to the
sink making sure it is not bent or twisted.
Use special plastic brackets delivered with the dishwasher (Figure
6
). The end of the
hose must be at a height of 400 to 1000 mm, and cannot be in the water to prevent water
withdrawal.
ATTENTION: To prevent any movement of the outflow hose and consequent water
spillage, it is necessary to fasten a special plastic bracket onto the wall.
Unit
min
400
mm
max
1000
mm
Top
Outflow pipe
∅ 40 mm
Fasten the hook of the outflow hose to the top
Outflow hose
fastening
Connecting the outflow hose. Install the outflow hose in A , B or C position lub.
6
STAGES OF INSTALLING THE DISHWASHER
1 Install the unit door onto the outside door of the dishwasher by means of delivered
brackets.
2 Adjust the tension of the door spring by turning an Allen key clockwise to tighten the
right and left spring. Any negligence in that matter may result in permanent damage to the
dishwasher (Figure 5 )
3 Connect the hose channeling cold water.
4 Connect the outflow hose.
5 Connect the power cable.
6
Install the compression belt under the working surface of the unit. Please make sure
that the compression belt is aligned to the edge of the working surface.
7 Place the dishwasher in the right spot.
8
Level the dishwasher by turning the bolts on the right and left side of the hosing
(Figure
7
(5A)). Use a spanner to adjust the front legs – turn them until the dishwasher is
leveled.
9 The dishwasher must be attached to the spot – there are two ways to accomplish it:
A. Standard working surface – fasten the dishwasher to the surface by screws making
sure that the weight of the dishwasher is not increased by the working surface (Figure
6 ).
B. Marbled or granite top – attach the brackets to the side panel of the dishwasher and
fasten the dishwasher to the unit. Place a rubber hood on the bolt (Figure
7
).
You must level the dishwasher to facilitate the functioning of the rack and the efficiency of
washing (Figure
8
).
1 Place the level on the door and the rail of the rack inside, as shown on the figure, to
check if the dishwasher is leveled.
2 Level the dishwasher by regulating four leveling legs.
3 Please be careful not to knock over the dishwasher during leveling.
1
4
7
5
5A
5B
6
2
Compression belt
Unit door
Bolt
Bolt
Rubber
Cap
Conical
Mechanism
7
Downloaded from DishWasher-Manual.com Manuals