Zelmer DOT VC1002, Руководство пользователя

Страница: 36 / 38

40
VC1002-002_v01
Dust bag disassembly/assembly
DOT vacuum cleaner is equipped with both SAFBAG bag
(1 piece) as well as a reusable bag (1 piece).
1 Total covering up of bag loading indicator by the red
cover in case the sucker or the brush is upraised over
the cleaned surface informs, that change of dust bag is
necessary. The bag loading indicator may operate in case
of suction hose stopping or in case of stopping of equipment
elements connected thereto.
2 Switch off the vacuum cleaner by pressing the on/off
button (3) .
3
Unplug the appliance.
4 Open the front cover handle (9) .
5 Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the vacuum
cleaner.
6
Release the hook locking the bag holder according to
the arrow on the hook and then remove the bag with the
handle up.
7 Put out the bag plate from the holder. Dump the filled bag
into the garbage.
8
Caution! Do not throw the bag holder.into the trash.
9 Slide the plate of a new bag into the handle and slide it
until the end of the handle.
10
Insert the handle with the new bag into the seat of casing
and lock it with the locking hook.
Carefully place the bag in such a way that the
hole in the bag plate was placed over the rubber
collar in the chamber of the vacuum cleaner.
11 Close the cover until you hear the characteristic clicking
sound – be careful not to catch the bag.
In case of using a reusable bag:
12 Release the bag fastening according to the arrow on it
and then pull the bag up to remove it.
13 Slid the closing board on the back part of the bag down
and empty out the contents.
If the bag is very dirt, you can wash it in water
with a little amount of washing agent.
If the bag was washed, it should be dried before
it is used again
14 Place the closing board on the back part of the emptied
bag.
15
Slid the bag into its place.
Carefully place the bag in such a way that the
hole in the bag plate was placed over the rubber
collar in the chamber of the vacuum cleaner.
Close the cover by pressing it until you hear a distinctive
●
click – be careful not to get the bag caught.
E
Do not vacuum without bag. In case if there is
no bag in the vacuum cleaner, the front cover
of the vacuum cleaner cannot be locked.
You should replace the bag, if:
a) the red field covers the bag full indicator,
b) the vacuum cleaner operates poorly,
c) the dust bag is full.
Special accessories
The following special accessories may be purchased in retail
outlets:
Parquet brush “BNB” (21)
Is used to clean and polish hard, scratch sensitive surfaces
such as wooden floors, floor panels, parquet, marble, tiles, etc.
Delicate and soft natural bristles ensure maximum vacuum
effectiveness and protects against scratching the cleaned
surface.
End of operation cleaning
and maintenance
1 Switch off the vacuum cleaner by pressing the “on/off”
button (3) .
2 Unplug the appliance.
3
Wind the cord by pressing the cord rewind button (1) .
While doing this hold the cord to make sure it is not tangled
and the plug does not hit the vacuum cleaner housing.
4 Disconnect the suction tube from the suction nozzle or
brush.
5
Disconnect the suction tube from the hose.
6 Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the vacuum
cleaner.
7 The vacuum cleaner may be stored in a vertical position
– just place the fastening hook of the combination brush
into the fastening of the combination brush. The hose may
be connected to the vacuum cleaner. Yet it is necessary to
make sure it is not bent to hard during storing time.
Horizontal storage:
place the fastening hook of the combination brush into
–
its fastening placed at the back of the vacuum cleaner,
near the cord exit.
Vertical storage:
place the combination brush on the telescopic tube,
–
place the fastening hook on the telescopic tube into the
–
fastening of the combination brush placed on the bottom
of the vacuum cleaner, near the front wheel.
8
If necessary wipe the housing and the dust bag container
with a damp cloth (it may be soaked with dishwashing liquid)
and dry it or wipe until dry.
Do not use abrasive detergents or solvents.
F