22
- Undo the four screws
72
, which connect left catch
7
and right catch
8
with the upper cover
9
; unfold catches
7
,
8
and remove the upper cover
62
with cover catch
60
and spring
68
.
- Undo the four screws
72
, which secure the side strip
6
; lift up the side strip and, without
detaching the pipe
36
from the inlet stub pipe
4
put it next to the base
43
.
- Pull the plug of the power cord through the opening located in the pocket
26;
remove the
26
.
- Open the outlet cover
40
and pull it out with the exhaust air filter
18
; without disconnecting
electrical wires gently remove the entire set (i.e. upper cover
9
, bottom cover
16
, suction
unit
12
) with base fins
43;
place it on the base and disconnect electrical wires from ring
contacts of the cord rewinder
23
.
- Disconnect electrical wires from contacts of the cord rewinder and remove the cord
rewinder
23
from the base grooves
43
.
- Unwind the power cord
24
wound on the spool
,
unfold catches of the labyrinth and push it
out of the spool; disconnect the power cord
24
from U contacts
and pull it out of the
labyrinth of.
Removing the suction unit
- Release the cover catch switch
60
, lift the upper cover
62
, remove the front container
52
and rear container
2
.
- Undo the four screws
71
in the upper cover
62
and remove the handle
53
.
- Detach the cover
59
from the upper cover
62
by disconnecting the wiring harness of the
electrical wires from the switches
55
and
57
, tighten the catches of the flexy tube grommet
10
and push it through the opening in the upper cover
62
.
- Undo the four screws
72
, unfold catch
7, 8
and remove the upper cover
62
; with the cover
catch
60
, and spring
68
.
- Undo the four screws
68
, which secure the side strip
6
; lift up the side strip and, without
detaching the pipe
36
from the inlet stub pipe
4
, put it next to the base
43
.
- Undo the four screws
72
, which connect the upper cover
9
with the bottom cover
16
.
Remove the upper cover
9
, upper gasket
11
and suction unit
12
.
- Disconnect electrical wires from the suction unit
.
Removing the pump
- Undo the four screws
72
, which secure the side strip
6,
remove the side strip
6
from the
base
43
and detach the pipe
36
from the inlet stub pipe
4
.
- Lift up the suction unit (built-in) and remove: Pump cover
35
, pump
32
.
- From the pump, remove: Set of pump wires
29
, fuse
27
.
- Remove: elbow-pipette
33
with pipe
36
, elbow
30
with the pipe and clamp band
69
and
shock absorber
31
.
