13
Restoring the MAS3 to Factory Defaults
Restoring the MAS3 to the factory defaults
There are many ways to program the MAS3’s remote capabilities. Most learning modes require the
MAS3 to be in standby mode before learning can begin. If the remote used to control the MAS3
were to be lost, and the MAS3 were programmed to power on during initial power up (as described
in
"Setting Power On Defaults"
on page 12), there would be no way to reprogram the MAS3 to ac-
cept new remote control codes. Therefore a means of resetting the MAS3 to its factory on defaults
has been included.
Resetting the MAS3 to the factory defaults is done by removing power to the MAS3. The AC wall
adapter must be unplugged, so that the MAS3 is completely without power. The
SETUP
key is then
pressed and
held
while power is restored to the MAS3, after about three seconds the power indica-
tor will flash three times indicating the MAS3 has been reset to factory defaults.
S
TEP
1
1
Remove all power from the MAS3, this can be done by unplugging
the AC wall adapter from the back of the MAS3, or unplugging the
AC adapter from the wall, or by using a switched power strip.
Nothing should be lit on the MAS3.
S
TEP
2
2
Using a pen or pencil, press AND HOLD the
SETUP
button on the
back panel of the MAS3. While continuing to HOLD the
SETUP
key, reapply power to the MAS3. When power is applied, the power
indicator light will light up indicating standby mode.
S
TEP
3
3
Continue to HOLD the
SETUP
key and after about three seconds
the power indicator will blink GREEN three times indicating the
MAS3 has been reset to its factory defaults.
The MAS3 factory defaults, are:
• Control codes used are the Symphonic TV codes.
• Default power up mode is standby.
• Default selected input when powered on is input 1.
• Default brightness mode is Auto-dimming.
3
2
1
ZEKTOR
3
2
1
ZEKTOR
3
2
1
ZEKTOR
