Zektor HDS4.2, Руководство пользователя, Страница: 5 / 20

5
1 2
3
4
5
6
7
8 9
0
PIP ENT
TV VCR
CBL /
SAT DVD RCVR
POWER
VOL
CH
+ +
_ _
Using the HDS4.2 with a Remote Control
Remote operations of the HDS4.2 are accomplished through the use of just about any remote con-
trol. A remote control is not supplied with the HDS4.2, yet the versatile programming modes of the
HDS4.2 allows the HDS4.2 to work with virtually any remote control. The next section "Program-
ming your Remote Control" on page 6, describes how to setup your remote controller. After your
remote control is programmed the following describes the pre-programmed functions of the
HDS4.2.
There are 10 separate remote controlled commands understood by the HDS4.2. They are:
•
P
OWER
T
OGGLE
.The HDS4.2 can be toggled from standby to pow-
er on, and back to standby using a single button of the remote.
•
S
ELECT
I
N
1
. Select input 1. If the HDS4.2 is in standby mode, it will
power on and then select input 1.
•
S
ELECT
I
N
2
. Select input 2. If the HDS4.2 is in standby mode, it will
power on and then select input 2.
•
S
ELECT
I
N
3
. Select input 3. If the HDS4.2 is in standby mode, it will
power on and then select input 3.
•
S
ELECT
I
N
4
. Select input 4. If the HDS4.2 is in standby mode, it will
power on and then select input 4.
•
P
OWER
OFF
. The HDS4.2 can be set to standby mode by pressing
a single button of the remote. Once the HDS4.2 is in standby mode,
further presses of the
P
OWER
OFF
button will be ignored. This com-
mand is useful when using the “macro” feature of some programma-
ble remote controls, and is used when it is unknown whether the
HDS4.2 is already in standby mode or not.
•
P
OWER
ON
. The HDS4.2 can be powered on from standby by press-
ing a single button of the remote. Once the HDS4.2 is powered on,
further presses of the
P
OWER
ON
button will be ignored. This com-
mand is useful when using remote controls that allow “macro” pro-
gramming, where it is unknown whether the HDS4.2 is already power
on or not.
•
S
ET
D
IM
M
ODE
. Toggles through three different bright/dim display
modes. They are: Bright all the time. Dim all the time. Bright for 4 sec-
onds after any keypress, and then automatically dim.
•
S
ELECT
+
. Select the next higher input. If input 4 is currently selected,
then this command will cause input 1 to be selected.
•
S
ELECT
-
. Select the next lower input. If input 1 is currently selected,
then this command will cause input 4 to be selected.