Zektor HDS4.2, Руководство пользователя

Страница: 14 / 20

14
Restoring the HDS4.2 to Factory
Defaults
Restoring the HDS4.2 to the factory defaults
There are many ways to program the HDS4.2’s remote capabilities. Most learning modes require
the HDS4.2 to be in standby mode before learning can begin. If the remote used to control the
HDS4.2 were to be lost, and the HDS4.2 were programmed to power on during initial power up (as
described in "Setting Power On Defaults" on page 13), there would be no way to reprogram the
HDS4.2 to accept new remote control codes. Therefore a means of resetting the HDS4.2 to its fac-
tory on defaults has been included.
Resetting the HDS4.2 to the factory defaults is done by removing power to the HDS4.2. The AC
wall adapter must be unplugged, so that the HDS4.2 is completely without power. The
SETUP
key
is then pressed and held while power is restored to the HDS4.2, after about three seconds the pow-
er indicator will flash three times indicating the HDS4.2 has been reset to factory defaults.
S
TEP
1
1 Remove all power from the HDS4.2, this can be done by
unplugging the AC wall adapter from the back of the HDS4.2, or
unplugging the AC adapter from the wall, or by using a switched
power strip. Nothing should be lit on the HDS4.2.
S
TEP
2
2 Using a pen or pencil, press AND HOLD the
SETUP
button on the
back panel of the HDS4.2. While continuing to HOLD the
SETUP
key, reapply power to the HDS4.2. When power is applied, the
power indicator light will light up indicating standby mode.
S
TEP
3
3 Continue to HOLD the
SETUP
key and after about three seconds
the power indicator will blink GREEN three times indicating the
HDS4.2 has been reset to its factory defaults.
The HDS4.2 factory defaults, are:
• Control codes used are the Yamaha VCR codes.
• Default power up mode is standby.
• Default selected input when powered on is input 1.
• Default brightness mode is Auto-dimming.
4 3 2 1
ZEKTOR
4 3 2 1
ZEKTOR
4 3 2 1
ZEKTOR