Zeiss S8, Инструкция по эксплуатации

Страница: 86 / 148

86
Operation
G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
OPMI
®
Vario: setting the adjustment speed for focus and X-Y cou-
pling as a function of the zoom setting
In this mode, you can select dynamic speed control for focusing and the
X-Y coupling.
The depth of field of the optical system changes as a function of the zoom
setting:
– If a large field of view (low zoom value) is used, this results in a large
depth of field, and the focus must be adjusted over a wide range to ob-
tain a sharp image. The X-Y coupling therefore needs to be adjusted
within a wide range to reach the position required. This means that
high adjustment speeds should be used in this case.
– A small field of view (high zoom value), on the other hand, results in a
small depth of field, and the focus has to be precisely set within a small
range to achieve sharp image definition. The X-Y coupling therefore
needs to be precisely adjusted within a narrow range until the position
required is reached. This means that it is advisable to use low adjust-
ment speeds for this purpose.
It is therefore a useful feature that the adjustment speed of the focus and
X-Y coupling can be varied in accordance with the zoom setting.
The instrument has been factory-adjusted for MEDIUM variation of the
adjustment speed as a function of the zoom setting. The best effect of dy-
namic speed control is achieved if an adjustment speed of <4.0 has been
selected in the speed mode.
Note:
The dynamic speed control is based on the basic speed selected for fo-
cusing and the X-Y coupling in the speed mode.
If you have already set a high adjustment speed for focusing and the X-Y
coupling in the speed mode, dynamic speed control may possibly not be
effective across the entire zoom range, as the maximum adjustment
speed is reached beforehand.
In the extreme case, if you have set the basic speed for focusing and the
X-Y coupling to the maximum value of 10, dynamic speed control will
have no effect at all.
In configuration mode 2, the top section (SPEED FUNCT:) of the display
and key field permits you to select a high, medium or low value for the dy-
namic change of speed, or to deselect dynamic speed control:
HIGH LOW
MEDIUM OFF
MODE
STORE MANUAL
SPEED
FUNCT:
MEDIUM
LIGHT
FUNCT:
MANUAL
POW ON
MODE:
MEM
Configuration
mode 2