Zeiss CenterMax, Руководство по эксплуатации

Страница: 150 / 166

9-6
Maintenance and care
61211-1020202 CenterMax Operating Instructions
Before placing a workpiece on the measuring table make sure that
the measuring table is clean.
• Remove larger particles with a vacuum cleaner.
• Then clean the measuring table with a mild cleaning agent.
Danger!
There must not be any grease film on the measuring table. Work-
pieces may slide and fall off the measuring table, thus presenting a
risk to the personnel. Before placing a workpiece on the measuring
table make sure that the measuring table is free from lubricants.
• Remove any greasy and oily substances from the measuring table.
Threaded holes
Dust may accumulate in the threaded holes and threads. In order to
ensure perfect condition of the threads, remove any dirt deposit from
the threaded holes with a vacuum cleaner.
Probe elements
Probe elements may be soiled e.g. by dust particles. Furthermore,
material from the workpiece being probed may settle on the probe
element, especially during scanning.
• Clean the probe elements with a fluff-free cloth.
• Use a cleaning agent if required.
Make sure that the probe element is free from cleaning agent resi-
dues.
The styli must be handled carefully. If force is exerted, the glued bond
between the probe element and the probe shank may be separated
and the probe shank may be bent or broken.
• Do not exert any force when cleaning.
If material from the workpiece settles on the probe element, it can be
removed with special solvents.
Removing aluminum
deposits
An aluminum deposit can be removed with 10% NaOH solvent (soda
lye) or with 10% KOH solvent (potassium lye). Make sure that the sol-
vents do not act too long since the glued bond between the probe
element and the probe shank may be affected. For cleaning, proceed
as follows:
• Wear rubber gloves and safety glasses.
• Immerse a cloth (e.g. cotton cloth) into one of the two solvents
and clean the probe element with the cloth.
!
NOTE