Never pressurize equipment beyond specified pressures as
shown on unit rating plate. Always pressure test with an inert
fluid such as water or dry nitrogen to avoid possible damage
or injury in the event of a leak or component failure during
testing.
Always protect adjacent flammable material when welding
or soldering. Use a suitable heat shield material to contain
sparks or drops of solder. Have a fire extinguisher readily
available.
Please follow standard safe practices regarding the handling,
installing or servicing of mechanical equipment. Read these
instructions thoroughly and follow all warnings or cautions
attached to the equipment. Consult local building codes and
the National Electrical Code(NEC) for special installation
requirements.
Understand the signal words: danger, warning and caution.
Identifies the most serious hazards which will result in severe
personal injury or death.
Signifies hazards that could result in personal injury or death.
Used to identify unsafe practices, which would result in minor
personal injury or product and property damage.
The manufacturer assumes no responsibility for personal
injury or property damage resulting from improper or
unsafe practices during the handling, installation, service
or operation of the equipment. The installation of Cabinet
Unit Heaters and all associated components, parts and
accessories shall be in accordance with the regulations of
all authorities having jurisdiction and must conform to all
applicable codes. It is the responsibility of the installing
contractor to determine and comply with all applicable codes
and regulations.
The installation of Cabinet Unit Heaters and all associated
components, parts and accessories which make up the
installation, shall be in accordance with the regulations
of all authorities having jurisdiction and must conform to
all applicable codes. Only trained and qualified service
personnel using good judgment and safe practices should
install, repair and/or service air conditioning equipment.
Untrained personnel can perform basic maintenance
functions such as cleaning coils and cleaning or replacing
filters. All other operations should be performed by trained
service personnel. When working on air conditioning
equipment, observe precautions in the literature, tags
and labels attached to the equipment and all other safety
precautions that may apply.
Improper installation, adjustment, alteration, service,
maintenance, or use can cause explosion, fire, electrical
shock or other hazardous conditions which may cause
serious personal injury and/or property damage. Consult a
qualified installer, service agency, or your sales representative
for information or assistance.
The equipment must always be properly supported by rigging
and lifting equipment. Any temporary supports used during
installation or maintenance must be designed to adequately
hold the equipment in place until equipment is permanently
fastened and set in its final location. All supports must meet
applicable local codes and ordinances.
All fastening devices must be designed to mechanically hold
the assembly in place without the ability to loosen or break
away due to system operation or vibration.
All power must be disconnected and locked out before any
installation or service is performed to avoid electrocution or
shock. More than one power source may be supplied to a
unit. Power to remote mounted units may not be supplied
through the unit.
Never use bulky or loose fitting clothing when working on any
mechanical equipment. Gloves should always be worn for
protection against heat, sharp edges and all other possible
hazards. Safety glasses should always be worn, especially
when drilling, cutting or working with chemicals.
Safety considerations
SAFETY CONSIDERATIONS
14
Содержание RW Series
Страница 31: ...29 SMART IDEAS Always the best climate for...