Zehnder Rittling Roda Twist Spa Air, Руководство пользователя

Страница: 23 / 100

EN
44
40016514
EN
Using your appliance
45
10/2017
4. Using your appliance
4.1 Switching the remote control on and off
You can turn the remote control on (the blower emits an audible signal) or off
(the blower emits two audible signals) by a long press on the button (more than 2
seconds).
The remote control must be turned off in order to access advanced settings ( see
chapter 4.10 ).
NOTE:
Switching off the remote control will put the blower on stand-by.
4.2 Switching the manual boost on and off
Press the BOOST key to start the blower for a set amount of time ( see chapter
4.10 , parameter 0 to modify it). The blower Boost indicator stays on throughout the
manual boost period.
Once the boost has started, you can adjust its operating time from between 15
to 120 minutes by pressing the + or - key repeatedly. You can stop it at any time simply
by pressing the BOOST key.
NOTE:
The total continuous blower operating time cannot exceed 2 hours (i.e. 120
minutes). An automatic 5-minute pause is programmed after 2 hours of
continuous operation.
NOTE:
When a boost ends, your blower operates for about 5 seconds in order to
remove the residual heat.
The symbol is displayed throughout the
duration of the manual boost. The time remai-
ning will scroll across the display until the end
of the preset period.
4.3 Desired temperature adjustment
You can adjust the desired setpoint temperature by pres-
sing the + or - key on your remote control within a range of between
7 and 28°C.
4.4 Daily programmes P1 and P2
When activated, functions P1 and P2 allow you to run one or two automatic
programmes every day at the same time. The settings for P1 and P2 are independent.
IMPOrTANT Starting a manual boost while P1 and/or P2 are activated will not
cancel the existing programming, which will take place as scheduled.
The desired temperature adjustment is impossible when a manual boost is
in progress. If you wish to modify the temperature, stop the manual boost by
pressing the BOOST key. Then set the desired temperature and restart the
manual boost by pressing the BOOST key again.
Access the advanced settings of your remote control to decide whether to
instruct the appliance to perform:
- a boost of the radiator alone,
- or a blower boost,
- or a radiator boost + blower boost. (default setting)
The selected parameter will affect programmes P1 and P2 ( see chapter 4.10 ,
parameter 3).
The blower boost time and the radiator boost time can be modified ( see
chapter 4.10 , parameters 1 and 2).