EN
Using your appliance 37
EN
36
40005957
40005957
Auto mode allows your radiator to receive remote operating instructions from a
programming base unit (not supplied with your appliance). These instructions arrive
either using a pilot wire to which your radiator is connected, or a PLC (Powerline Carrier)
programming base unit via your electrical system.
If you're using a programming base unit, the mode transmitted will correspond
to your radiator's regular modes (NO HEAT, FROST PROTECTION, ECO, COMFORT).
It can also switch your radiator to two additional modes (COMFORT -1°C and
COMFORT -2°C).
Set the setpoint temperature on your radiator which corresponds to your requi-
rements in COMFORT mode using the
–
and
+
keys, then select AUTO mode by
pressing the
MODE
key repeatedly. Then consult the instructions supplied with your
programming base unit for information on operating your radiator with it.
If you're using a PLC programming base unit, please consult the instructions
supplied with it as well as the PLC association/disassociation paragraph for more
information (see chapter 4.4).
AUTO mODE INDICATOr
PrOgrAmmE P1
This programme can be selected when you need to heat your
room from 5 am to 11 pm (e.g. permanent presence).
PrOgrAmmE P2
This programme can be selected when you need to heat your
room from 5 am to 9 am and from 5 pm to 11 pm (e.g. work day).
PrOgrAmmE P3
This programme can be selected when you need to heat your
room from 5 am to 9 am, from 12 pm to 2 pm and from 5 pm to 11 pm
(e.g. work day with lunch break at home).
3.4 Override
In your radiator's programmed operating modes (P1, P2 and P3, or AUTO mode
operated by an external base unit), you can locally override the operation of your
radiator by modifying the desired temperature level.
The override will end the next time the operating mode changes at the radiator's
or programming base unit’s request.
3.5 Stopping the heating
Press and hold the key to stop the heating of your appliance. The appliance
then emits two audible signals.
If programme P1, P2
or P3 in progress
If AUTO mode
in progress
1st time
– or
+
pressed
● Modifies the
desired temperature.
● Symbol shown,
indicating override.
● Instruction sent by
the base unit displayed.
● If it blinks, the
instruction from the
base unit cannot be
overridden (no step 2).
2nd time
– or
+
pressed
● Modifies the
desired temperature.
● Symbol shown,
indicating override.
ThE rADIATOr DOES NOT hEAT.
Содержание Fare LCD
Страница 1: ...Zehnder Fare LCD Manual ...
Страница 79: ...156 40005957 PL ...
