Zehnder Rittling ComfoAir 160, Руководство пользователя

Страница: 17 / 20

13 - EN
2.4 Maintenance by the user
The following maintenance must be carried out by the
user:
• Replacing the filters;
• Cleaning the valves (in the dwelling).
A concise explanation of these maintenance activities is
given in the paragraphs below.
Failure to carry out (periodic) maintenance on
the ComfoAir ultimately compromises the per-
formance of the ventilation system.
2.4.1 Replacing the filters
If so indicated on the digital operating device, the fil-
ters must be cleaned or replaced.
Replace the filters (at least) once every six
months.
• On the display the message “FiL” and ”tEr” will ap-
pear alternately.
• On the CC Ease panel "FilterI" will appear.
Toreplace...
1. Press “ OK ” on the display or press " " on the
CC Ease panel for at least 4 seconds until the filter
alert disappears.
2. Disconnect the power from the ComfoAir.
3. Remove the filter caps (A) from the ComfoAir.
4. Remove the old filters (B) from the ComfoAir
5. Slide the new filters back into the ComfoAir.
6. Refit the filter caps (A) to the ComfoAir.
7. Reconnect the power to the ComfoAir.
WhenusingtheComfoAirforthefirsttime,itis
recommendedtoreplacethefiltersandclean
thevalvesfirst.Duringtheconstructionphase
theventilationsystemcouldhavebecomedirty
withbuildingdust.
2.4.2 Cleaning the valves (in your dwelling)
The ventilation system may be fitted with the following
valves:
Exhaust valve (STB) Exhaust valve (STC)
Exhaust valve (STV) Exhaust valve (STK) Supply valve (STH)
Exhaust valve (STB) Exhaust valve (STC)
Exhaust valve (STV) Exhaust valve (STK) Supply valve (STH)
Exhaust valve (STB) Exhaust valve (STC)
Exhaust valve (STV) Exhaust valve (STK) Supply valve (STH)
You must clean the valves (at least) twice a year:
1. Mark the setting of the valve;
2. Remove the valve from the wall or ceiling;
3. Clean the valve in a solution of soap and warm water;
4. Rinse the valve thoroughly and wipe dry;
5. Place the valve back WITH EXACTLY THE SAME
SETTING (and IN THE SAME HOLE);
6. Repeat this procedure for the other valves.
About the valve settings...
The ventilation air is supplied and discharged by means
of valves. Gaps near doors in the dwelling ensure that the
air flows in the right direction. In order to ensure that the
correct ventilation volumes are maintained in the rooms,
the following must be observed:
•
do not seal the gaps;
• do not change the settings of the valves;
• do not swop the valves.