11
18.
Set Ignition Map SW
Enabling, or disabling external switch for changing ignition curves while riding.
Enter
Set Ign.
menu and move to
Ign. Map SW
with pressing + , or - and press ENTER .
Enable, or disable external switch with pressing + , or - and press ENTER .
19.
Set PULSES PER REV
It is number of pulses per rev from pickup coil and is important for correct rev reading. Set 1 for
single cylinder engines. Set 2 for all twins with wasted spark ignition system.
Enter
Set Ign.
menu and move to
Pulses Per Rev
with pressing + , or - and press ENTER .
Change nr. of pulses per rev with pressing + , or - and press ENTER .
20.
Set STOP SWITCH MODE
Stop switch can be set as 'low stop', or as 'high stop'.
Low stop operation ... engine stops with low level signal (stop switch connected to the ground)
High stop operation ... engine stops with high level signal (stop switch is opened)
Enter
Set Ign.
menu and move to
Stop SW Mode
with pressing + , or - and press ENTER .
Change stop switch mode with pressing + , or - and press ENTER .
21.
Set TRIGGER MODE
Enter
Set Ign.
menu and move to
Trigger Mode
with pressing + , or - and then press ENTER .
Change
Trigger Mode
with pressing + , or - and then press ENTER .
Trigger signal from pickup consists of positive and negative pulse. Positive pulse must be first and
is generated by leading edge of trigger lobe ... negative pulse must be second and is generated by
trailing edge of trigger lobe.
If trigger signal is opposite (first negative and second positive), then wires from the pickup needs to
be switched ... that changes polarity of signal from pickup.
Positive pulse defines static angle position and negative pulse defines idle running timing position.
