ZedCam™ Limited, contact via
www.ZedCam.com
or 08450 175 193
User Manual version V1.7 (April 2008) page 5
Single location control unit
1mW output with up to 10 metre control of camera
1 x 12 Volt 23A type battery
WireFree Trigger Units
The Trigger unit can be used with three alternative alarm sources:
o
A pressure mat
o
A magnetic switch
o
A PIR sensor
When the trigger is used with a pressure mat, the camera will be turned on when
someone steps on the mat placed under a carpet. With the magnetic switch, the camera
turns on when a door, window or even a desk drawer is opened. And with the PIR sensor
the camera turns on when someone approaches the trigger. Several trigger units can be
used with one camera controller.
The operation of the unit is the same for all three alarm sources, except that the buzzer is
not available for the PIR sensor.
For information only – these links are factory set!
There are 8 selection links on the trigger unit as follows.
A - Link On
Selects 60 second timeout before camera OFF
No Link
Selects 10 second timeout before camera OFF
B - Link On
Enables beep and LED flash when an alarm is detected.
No Link
No beep or LED flash when alarm is detected
C -
Not used
D -
Not used
E - Link On
Enables Trigger unit to turn camera OFF
No Link
Trigger unit does not turn camera OFF
F - Link On
Enables auto wake when alarm is detected
No Link
No auto wake when alarm is detected
G - link
Camera select (see below)
H - link
Camera select
