1
A few simple tools are required:
- Measuring tape
- Power drill, drill bits
-
1
⁄
4
”
Hex head and/or Phillips driver bit
- Pencil
GETTING STARTED
1 1⁄4”
Hex Head
Bracket Screw
Head Rail
Extension
and Sidemount
Bracket (optional)
Spacer
Block
(optional)
Additional fasteners other than
those sent with your shading may be
required depending on the mounting
surface. Wallboard and plaster require
the use of anchors such as expansion
or toggle bolts. Brick, tile or stone
need special plugs and drill bits.
Remember to always pre-drill holes in
wood to avoid splitting.
Mounting
Bracket
Hold
Down
Bracket
(optional)
STEP 1: BRACKET INSTALLATION
PN: CS5402
PN: 20201012
PN: CS1000
PN: CS2000
PN: KIT9108
Shadings are shipped with the required number of brackets
for proper installation. End brackets should be located
approximately 3” from either end. Depending on the width
of the shading, additional brackets may be necessary, evenly
spaced between the two end brackets.
If mounting the battery
wand to the head rail, bracket positions may need to be
adjusted to accomodate the battery wand. You must have at
least 20” between bracket centerlines to fit the battery wand.
Using the installation bracket as a template, measure to the
edge of the bracket and mark the hole locations with a pencil
for drilling.
Brackets must be in line and level. Shim brackets on inside
mounts if necessary. The head rail must be level for the shading
to operate properly.
Shading Width
# of Brackets
Up to 40”
2
>40” - 72”
3
>72”- 84”
4
>84” and up
5
INSIDE MOUNT
The minimum mounting depth for an inside mount is 1
”
.
A minimum of 3
3
⁄
4
”
is needed to fully recess the shading.
Make sure the brackets are level and aligned.
Attach each bracket using two screws.
Inside Mount
Shallow Mount - Minimum 1
”
surface
Flush Mount - Minimum 3
3
⁄
4
”
surface
1
”
Wall
Mount
Battery
Wand Clip
Head rail
Mount
Battery
Wand Clip
3”
3”
20” min. between
bracket center
lines to mount
battery wand to
head rail
