Zebex Z-6070 Series, Руководство пользователя, Страница: 17 / 29

Dual-Laser Omnidirectional Scanner 10
U
SER
’
S
M
ANUAL
Replacing the Interface Cable
The standard interface cable is attached to the scanner with an 8-pin modular I/O-connector.
When properly seated, the connector is secured in the scanner handle by a flexible retention
tab. The cable is designed to be field replaceable. Replacement cable can be obtained from an
authorized distributor.
To replace the cable, the following steps should be followed.
1.)
Make sure that the power of your computer system is switched off.
2.) Disconnect the scanner cable from the computer system.
3.) Use a pin to press down the small hole situated at the back of the scanner where the
cable is attached.
4.) Straighten one end of paper clip.
5.) Pressure down the pin, and pull the connector out, the cable is loosed.
1
2
Figure 9