U
SER
’
S
M
ANUAL
Wireless Handheld Gun Type 2D Image Reader
89
Start Of Configuration
20.
Imager Preferences
Barcode
Value
Barcode Label
Description
IP00
Decoding Autoexposure enable
Select enable Decoding Autoexposure to allow the SE4500 to
control gain settings and exposure (integration) time to best
capture an image for decode mode
IP01
Decoding Autoexposure disable
IP02
Decoding Illumination enable
Selecting enable Decoding Illumination causes the decoder to turn
on illumination every image capture to aid decoding. Select
disable Decoding Illumination to prevent the decoder from using
decoding illumination
IP03
Decoding Illumination disable
IP04
Decode Aiming Pattern enable
This parameter only applies in Decode Mode. Select Enable
Decode Aiming Pattern to project the aiming pattern during bar
code capture, or Disable Decode Aiming Pattern to turn the
aiming pattern off
IP05
Decode Aiming Pattern disable
IP06
Aim Brightness
This feature sets the brightness of the aim pattern. The default is
0, which indicates that the aim pattern is always on in between
camera exposures. For values above 0, each increment of the
brightness value increments the aim duration 0.5 ms
IP07
Illumination Brightness
This feature sets the brightness of the illumination by altering LED
power. The default is 10, which is maximum LED brightness. For
values from 1 to 10, LED brightness varies from lowest to highest
level of brightness
SET
Confirm to save this setting (required for reading full
ASCII table and length setting)
End Of Configuration
