U
SER
’
S
M
ANUAL
Wireless Handheld Gun Type 2D Image Reader
99
Appendix 2: Barcode Length Setting
Introduction
The length of a barcode is the number of characters it contains, including check digits.
As listed in the Default Parameters section, each barcode type has different default
length. You may change the setting by the following procedure.
To set up barcode length, the paramours to be determined are barcode type and the
desired barcode length. Barcode length is consisted of 2 digits. For numbers smaller
than 10, you need to add a “0” in the front.
Example
If the barcode length is 4 to 12 digits, the steps would be as below:
End
Set up barcode length
Start
Set up minimum
barcode length
Start of Configuration
Set up maximum
barcode length
End of Configuration
Scan the “
Start of
configuration
” barcode
Scan the “
Set
”
barcode to save this
setting
Scan the
“
Min
“
barcode
Set the “
Max
”
barcode
Set up the
second digit:
2
Scan the first
digit:
0
Scan the second
digit:
4
Turn to the page of the
barcode type to be set
up
Read the “
Full ASCII
code 39
” barcode
Set up the first
digit:
1
Scan the “
End of
configuration
”
barcode
Use the ASCII table (Appendix 4) to set up barcode length. Be sure to enable
the full ASCII code 39 option before you start and read the “Set” label to set
your choice into memory.
