ZEAK 2500LB, Руководство пользователя

Страница: 17 / 20

6.TROUBLESHOOTING
Use the table below to troubleshoot problems before contacting service
personal or your local dealer. If the probem continues after troubleshooting,
call your local dealer for istance.
Follow all safety precautions whenever diagnosing or servicing the tool
Disconnect power supply before service.
14
Failure Possible Cause Corrective Action
Motor overheats
1.Incorrect power cords
2.Winch is running too long
1.Use only supplied power cords
2.Allow winch to cool down periodically
Motor does
not turn on
1.Remote battery is dead
2.Loose battery cable connec-
tions
3.Vehicle battery needs charging
4.Solenoid is malfunctioning
5.Remote damaged
6.Defective motor
7.water has entered motor
8.Internal damage or wear
1.Replace remote battery
2.Tighten nuts on all cable connections
3.Fully charge battery
4.Tap solenoid to loosen
contacts. Apply 12 volts to coil
terminals directly. A clicking
indicates proper activation
5.Replace remote
6.Check for voltage at armature port with
switch pressed. If voltage is
present, replace motor
7.Allow to drain and dry. Run in
short bursts without load until
completely dry
8.Have technician service winch
Motor runs but
wire rope
drum does not
run
Clutch not engaged
Move the clutch handle to the
engaged position. If problem persists,
a qualified technician needs to check
and repair
Motor runs
slowly or
without normal
power
1.Insufficient current or
voltage
2.Loose or corroded battery
cable connections
3.Incorrect power cords
1.Battery weak, recharge it. Run
winch with vehicle motor running
2.Clean, tighten, or replace
3.Use only supplied power cords
Motor runs in
one direction only 1.Defective or stuck solenoid
2.Remote damaged
1.Tap solenoid to loosen contacts Repair
or replace solenoid
2.Replace remote