Wiring
To prevent serious injury from explosion (sparking at the battery connection),
disconnect the battery cables before making other wiring connections.
To prevent serious injury from leaking battery acid, do not use a dirty, corroded
or leaking battery. Only use a 12V automotive (or equivalent) battery, in good
condition.
1.Plan a route for the wiring from the point of the vehicle where the winch will
be mounted, or used, to the battery. This route must be secure and out of the way
of moving parts, road debris, or any possibility of being damage by operation or
maintenance of the vehicle.
For example, you may wish to route the wires under the vehicle, attaching it
to the frame using suitable fasteners Do not attach the wires to the exhaust
system, drive shaft, emergency brake cable, fuel line, or any other components
which may create damage to the wiring through heat or motion, or create a fire
hazard.
2.If you drill through the bumper or any part of the body to route the wires, be
sure to install a rubber grommet in the hole to prevent fraying of the wires at that
point.
3.Route the cables from the solenoid to the battery and from the solenoid to
the winch, following the precautions discussed above. See the following picture.
4.Attach the wires from the solenoid to the terminals on the winch.
5.Attach the circuit breaker to the positive terminal on the battery.
6.Attach the red battery cable to the circuit breaker.
Wiring Connection
(Note: The attachment of the motor cables determines the operation of the
remote’s button. After the unit is mounted and powered, check the direction of
the Power In and Power Out on the remote button. If you wish to change the
direction on the remote, disconnect the battery cables from battery, switch the
motor cable connections on the motor, then reconnect the battery cables.)
8
Содержание 2500LB
Страница 1: ...ZEAK 2500LB WINCH ...
