8
Function of the Zeagle System
The Winglet Side Release Buckles
must
be attached to the vest.
Surface Buoyancy
Label Location
Do NOT dive with the two winglet side release buckles detached!
Bladder Assembly
The bladder assembly attaches to the vest section via four stainless
steel slotted fasteners sewn to inner edge of the bladder assembly. Each
of these slotted fasteners slides over the two Single-Tank Bands. This
fastenes the Bladder to the Tank Bands. If the BC is to be used with
double tanks, then the single tank bands are removed and the optional
double tank straps (p/n 7281M) slide through the webbing slots at the
back of the vest just as the removed single tank bands did (see cylin-
der band illustration on pages 10 thru 13). The stamped metal ends of
the straps are threaded through the eye of the metal tabs on the Blad-
der Cover (see illustration below). There are two plastic buckles on the
Bladder Cover Winglets, which clip over the weight pockets to hold the
buoyancy forward.
Do not dive with the two forward small side release
buckles detached!
The shoulder straps should pass through the collar
at the top of the bladder assembly.
Shoulder strap goes
through the collar
The Tank Bands and the optional dou-
ble tank straps go through the same
backplate webbing slots.
Optional double-tank Straps are
required
IF
Double Tanks are
mounted to the BC.
p/n 7281M (2 required)
