17
Pre-dive Assembly and Inspection
• Return the Ripcord handle to the secure position.
• Pull the cord through for the right side weight pocket.
• Start with the loop closest to the Ripcord handle.
• Each white nylon loop is threaded through three grommets. The
cord is then threaded through the end of the white loop.
• Thread the cord under the webbing that is between the grommets.
• Repeat for all nylon loops.
• Finish by pushing the cord between the pocket and the vest.
• Repeat on the opposite pocket.
Cord
If the Ripcord is not completely secure, re-thread using the following
procedure.
Nylon Loops
Cord
Re-threading The Ripcord
TM
System
Check to see that weight release system is secure.
Trim Weight
™,
Pull-Out Pocket
™
Velcro Touch Fastener System
- Check to see that the touch fastener material fl ap on the bottom and
sides of each weight pocket completely overlaps and is secure.
Trim Weight™
Pull-Out™
