zazen Alkaline Water | [email protected] | 1300 78 24 25 | zazen.com.au
4
Place the stand where you will sit
your System.
Place the lower tank onto stand.
Place the tap “A” through hole in the lower
tank with a silicon washer “B” on each side.
Screw the magnetic back “C” onto tap
inside the bottom tank and tighten.
Put pre-soaked Silver Stones and
Mineral Stones into lower tank.
*If you have Alkalinity Enhancers (AAE) balls
sprinkle amongst the stones away from the
back of the magnetic tap so they can’t get
sucked into the back of the tap.
Place the middle ring onto the lower
tank rim.
Screw the Multi-Stage Filter Cartridge into
cartridge connector and sit in middle ring
(filter will hang in lower tank).
Place the silicon washer* onto the Ceramic
Filter stem and then insert the Ceramic
Filter into the hole inside the upper tank.
Fasten on with the filter nut* and tighten.
Place the top tank onto the assembled
lower tank.
Fill top tank with 4 litres of tap water and
pop on the lid.
Note: It will take 1½ to 2 hours to filter the 4 litre upper tank
into the lower tank. Do this twice to fill your system. Once the
lower tank is full, you cannot add more water to the upper tank
or the system will overflow.
*Washer & nut come with Ceramic filter
SCAN TO VIEW
OUR ONLINE
INSTALLATION VIDEOS
1
2
3
4
5
7
6
8
9
Installation & Care Guide
Assembling your zazen Alkaline Water System
with the BPA Free Plastic Bottom Tank
CERAMIC FILTER
SILICONE WASHER
UPPER TANK
FILTER NUT
CARTRIDGE CONNECTOR
O-RING
MULTI-STAGE FILTER CARTRIDGE
LID
A - TAP
B - SILICONE WASHERS
C - MAGNETIC BACK
LOWER TANK
STAND
SILVER & MINERAL STONES
MIDDLE RING
A
B B
C
9
7
8
6
5
4
2
1
3
