Zapi COMBI AC1, Руководство пользователя

Страница: 46 / 86

12) HS CUTBACK
Typically from 10% to 100%. It determines the percentage of the max speed
applied when the Hard & Soft function (H&S switch on CNA#6 in AmpSaab
connector, CNA#29 in AmpSeal connector) is active. When set to 100% the
speed reduction is ineffective.
13) CUTBACK SPEED 3
Typically from 10% to 100%. It determines the percentage of the max speed
applied when the cutback switch 3 is active. When set to 100% the speed
reduction is ineffective.
14) FREQUENCY CREEP
Hz value. This is the minimum speed applied when the forward or reverse
switch is closed, but the accelerator is at its minimum.
15) MAXIMUM CURRENT
Maximum level of the current (percentage of the maximum current of the
controller).
16) INCHING SPEED
To set the speed (percentage of the maximum speed) in the inching mode.
17) INCHING TIME
When the inching mode is active for a period of time higher then this value,
the truck automatically stops and the operator must do a new request to
restart.
18) ACCELERATION SMOOTH
It gives a parabolic form to the acceleration ramp.
19) INVERSION SMOOTH
It gives a parabolic form to the acceleration ramp after a direction inversion.
20) STOP SMOOTH
Hz. It sets the level of frequency where the smooth effect of the acceleration
parabolic form ends.
21) BRK SMOOTH
It gives a parabolic form to the deceleration ramp.
22) STOP BRK SMOOTH
Hz. It sets the level of frequency where the smooth effect of the deceleration
parabolic form ends.
23) AUXILIARY TIME
Time units value (seconds). For the encoder version, it determines the time
duration the truck is hold on the ramp if the STOP ON RAMP option is ON.
Page - 46/86 AEQZP0BA – COMBI AC1 - User Manual