9
4.4
Battery installation and removal
Slide the fully charged battery from top to bottom onto the tool as (FIGURE 4) shown.
The light should be in “off “ status. Always check and make sure release button pops
up after the battery is installed.
FIGURE 4.
Illustration of Inserting and Removal of Battery
*
When the operation indicator shows “Red flashing”, it means the battery power
is too low to work and needs to be re-charged.
Then the tool is NOT supposed to be
operated under such condition. You will simultaneously hear “Beep..beep..beep”
alarm. Please press “Battery Release Button “ on top of battery and pull battery upward
to remove it from the tool. The “ beep..beep” alarm will continue until the battery is
removed. (FIGURE 4)
4.5
Sealing time adjustment
Sealing time is adjustable from 0.6 ~4.8 seconds. Please set a proper sealing
time in accordance with the strap’s quality and specifications. Sealing time
setting as below shown.
Sealing time adjustment knob has 14 increments, each increment equals
to approximately 0.3 seconds.
A tip to set proper sealing time
.
Suggest to cut off a length of strap and fold it into two sections. Put the overlap section
〈
REFERENCE
〉
PET
25mm x 1.27mm requests approx. 2.1 seconds
PET
25mm x 1.05mm requests approx. 1.5 seconds
PET
19mm x 1.27mm requests approx. 1.8 seconds
PET 19mm x 1.05mm
requests approx. 0.9 seconds
PET 16mm x 1.05 mm
requests approx. 0.6 seconds
PP 15mm x 0.85mm
requests approx. 0.6 seconds
