Zanussi ZWT10710W, Руководство пользователя

Страница: 14 / 32

Problems without alarm messages
Description Inspection Items
The appliance is not washing If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.(The
washer will not work if the water amount does not reach the re-
quired water level)
If it is set to "Delay" washing mode. (It will only start to work until
the reservation time reached)
No water flows in If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is
opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched
on)
If the "Start / Pause" button is pressed after the power switch is
pressed.
Abnormal draining If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
Abnormal spin If the door lid is not closed properly.
If all clothing piled largely at one side of barrel or the clothing is
excessively placed.
If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
If the motor belt is loosened.
If the problem occurs again, contact the Authorised Service Centre.
TECHNICAL DATA
Dimension Height x Width x Depth 965mm x 550mm x 578mm
Electrical connection Voltage
Overall power
Fuse
Frequency
220-240 V
510 W
10 A
50 Hz
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture.
IPX4
Water supply pressure Minimum
Maximum
0.3 bar (0.03 MPa)
8 bar (0,8 MPa)
Water supply
1)
Cold water
Hot water
Maximum load 10 kg
14