8
•
The washing machine has stopped with water in
the tub
, at the end of a programme with the
“Rinse Hold”
or “
Night Cycle
”
option: this is indicated by a
flashing zero
. The
“
Door
” light will be lit and the door will be locked.
•
The washing machine has completed the
programme
: this is indicated by a
flashing zero
. The
zero will reappear when you switch the washing
machine on, unless the previous programme has been
erased by turning the programme selector dial to the
“
O” Off
position. The “
Door
” light will be off and
the door can be opened.
Important!
The first time you use the washing machine
, when
you switch it on, it may display a flashing zero and give
an audible warning signal. This is due to the fact that the
washing machine has performed a washing cycle during
the manufacturer’s inspection tests, and this cycle has
not been erased after its completion.
•
Delay start
, a time value indicated in hours and
selected by means of the relevant button (max 23
hours).
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
0
After you have pressed the “
Start/Pause
” button, the
countdown begins, and the delay time value decreases
by one unit every hour and then, when 2 hours remain,
the time decreases in 30 minute intervals.
You can delay the start of the selected programme by
up to 23 hours in one hour intervals.
•
An incorrect option selection has been made
: this is
indicated by the message
Err
when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible
warning signal.
•
An alarm code
indicates a fault in the machine
operation (see the relevant chapter on page 20).
8 “Delay Time” button
This button makes it possible to delay the starting of the
programme selected from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option
after
you have set the
programme and
before
you press the “
Start/Pause”
button.
The time value shown on the display will decrease by
one unit every hour.
E20
132978490.qxd 10/01/2007 10.46 Pagina 8
