NON-STOP PROGRAMME
1. Turn the programme knob to the desired
programme to activate the appliance.
2. Load the laundry one item at a time.
To have a good drying performance do
not exceed the maximum drying loads
recommended in the user manual. Do
not set a spin speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives in the
appropriate compartment.
4. Turn the programme dial to the washing
programme.
The display shows the indicators of the different
washing phases.
5. Set the available options.
WASHING & AUTOMATIC DRYING
1. Press again and again until the display
shows one of the dryness level indicator:
•
: IRON DRY level indicator for cotton
items
•
: CUPBOARD DRY level indicator for
cotton and synthetic items
•
: EXTRA DRY level indicator for cotton
items
The display shows the indicator . The time value
on the display is the duration of the w
drying cycles, calculated on a default load size.
To have a good drying the appliance
does not let you set a too low spin
speed for the items to be washed and
dried.
2. Press
to start the programme.
In the display the indicator of the set dryness level
stays on.
The door locked indicator
goes on.
The display shows regularly a new time value.
The last minutes of the drying cycle
the appliance performs the anti-crease
and the cooling phases.
WASHING & TIMED DRYING
To have a good drying the appliance does not let
you set a too low spin speed for the items to be
washed and dried.
1. Press
to set the drying time value. The
display shows 10 minutes.
The indicator comes on in the display. The
display shows the set drying value time. for
example:
. After some seconds the display
shows the final time value
, that is the total
duration of the washing and drying cycles (washing
+ anti- cooling phases).
If you set only 10 minutes of drying
after washing, the appliance calculates
also the duration of the anti-crease
and the cooling phases.
2. Press
to start the programme.
In the display the indicator
comes on. The door
is locked. The display shows regularly a new time
value.
END OF THE PROGRAMME
The appliance stops automatically. The acoustic
signals operate (if they are active).
For more information see "At the end of the drying
programme " of the previous chapter.
1. Remove the laundry from the appliance.
Make sure that the drum is empty.
2. Keep the door ajar to prevent mildew and
odours.
3. Close the water tap.
FLUFF IN THE FABRICS
During the washing and/or drying phase, some
types of fabric, (sponge, wool, sweatshirt) could
release fluff.
The released fluff could stick to the fabrics during
the next cycle.
To prevent the fluff in your laundry, we recommend
that you:
• Do not wash dark fabrics after you have washed
and dried light coloured fabrics (new sponge,
wool, sweatshirt ) and the contrary.
• Line dry this type of fabrics at open air when
they are washed the first time.
• Clean the drain filter.
• After the drying phase, clean the empty drum,
the gasket and the door with a wet cloth.
23
