Zanussi ZWD141K, Руководство пользователя

Страница: 4 / 42

4
INSTALLATION
• Refer to the installation instructions supplied
separately.
• The installation must ensure protection against
direct contact with live parts.
• The electric system must be equipped with
an isolation switch providing all-pole contact
separation which provides for full disconnection
under overvoltage category III.
• A plug must be used for the electrical connec-
tion; this must remain accessible after installa-
tion.
Warning! Before connecting the appli-
ance, compare the power supply data
(voltage and frequency) indicated on the
data plate with those of the mains supply.
If these data do not match there may be
problems. In case of doubt, contact an
electrician.
Warning! If the appliance is to be
connected without using a plug (hard-
wired), the appliance must be installed
and connected by a technician. Contact
a qualified electrician who will perform
the work in accordance with electrical
code and comply with all provisions of this
manual. The manufacturer cannot be held
responsible for damage resulting from
installation or connection errors.
Warning! The electrical safety of the
appliance can only be guaranteed if it is
properly earthed. The manufacturer cannot
be held responsible for damage resulting
from the absence of or defects in the
installation’s protective earthing system
(e.g. electrical shock).
Warning! Only use the appliance once it
has been fully installed. Only full and final
installation within the kitchen unit carcase
can ensure that there is no risk of contact
with live parts.
Warning! Never open the appliance’s
structure. Potential contact with live parts
or any modifications to the electrical and
mechanical structure can lead to hazard-
ous situations for users and compromise
correct operation of the appliance.
CLEANING
• Do not use harsh abrasive cleaners or metal
scrapers/scourers to clean the device since they
can scratch the surface.
• Do not use steam cleaners to clean the appli-
ance.
• Do not use high pressure or steam jet cleaning
devices. The steam may affect electrical compo-
nents and cause a short circuit. The steam pres-
sure may also cause damage to the appliance’s
surface and components in the long time.
REPAIRS
• If the appliance’s power supply cable is dam-
aged, it must be replaced by the manufacturer,
by an authorised technician or by a qualified
electrician in order to negate any potential
hazards.
Warning! The appliance must be isolated
from the electricity supply when installa-
tion and repair work is being performed.
To disconnect the appliance from the
current, one of the following conditions
must be met:
• The relevant fuses / circuit breakers
at the switchboard must be discon-
nected.
• The plug should be removed from
the socket. To remove the plug from
the socket do not pull on the electric
cable but rather pull out the plug itself
directly.
Warning! Repairs and maintenance,
especially of live components, must only
be performed by technicians authorised by
the manufacturer. The manufacturer and
retailer do not accept responsibility for
any injury to people or animals or damage
to personal property as a result of repairs
and maintenance carried out by non-au-
thorised personnel.
Warning! Repairs undertaken during the
warranty period must only be performed
by technicians authorised by the manufac-
turer. If this is not the case then any dam-
age resulting from the repair in question
shall be excluded from the guarantee.