38
Fitting a decorative door panel
Important :The components needed to fit the
decorative panel have been pre-fitted on the
appliance. The brackets are secured to the
panel by means of the 7 Ø 3.5x13 screws
supplied. Before starting to fit the panel,
remove the large top bracket by unscrewing
the screws and adjusting pins prefitted on
the appliance door. The small bottom
bracket need not be removed.
Fig. 6
Lay the panel face down (Fig. 6). Position the
top bracket on the panel, making sure that there
is an equal distance between it and the sides
and that its distance from the top edge is equal
to distance (A) less 1 cm. Secure the bracket
with the screws supplied. Take care not to
damage the front face of the panel whilst
working.
Fig. 7
Insert the adjusting pins (BFig. 7) into their
locations in the door and screw them in.
Fig. 8
Hook the decorative panel onto the top part of
the door, inserting the pins (B) (on the door) into
the elongated holes (1) (in the top bracket fitted
to the panel) (Fig. 8).
Insert the securing screws (C) through
elongated holes (2) and fix the panel without
tightening the screws (Fig. 8).
Fig. 9
Once the top of the panel has been correctly
positioned, fix it through the holes in the bottom
bracket, without tightening the screws (Fig. 9).
Fig. 10
Check the position again by slackening the
screws and pins then, once the best position
has been obtained, fully tighten all the fixings.
Cover the visible part of the top bracket on the
panel with plastic cover (D), inserting it in the
locations provided in the bracket.
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
D468
A
-1cm
=
=
D532
B
D533
1
B
2
C
D471
D472
D
