Fig. 1
Fig. 2
Fig. 3
Location
Fig. 1
This appliance is designed to be built-in to a
space having the dimensions given in Fig. 1.
Fig. 2
The height of the appliance can be altered if
required by means of adjustable feet situated at
its base (Fig. 2).
Door reversibility
Remove the two screws which fix the upper
hinge to the door.
Fig. 3
Carefully lean the appliance on its back and
remove the plastic insert (Fig. 3).
Remove the two screws which fix the lower
hinge to the door.
Remove the four screws which fix the lower
hinge to the base of the appliance and remove
the hinge itself; be very careful to recover all the
screws.
Remove the four screws that fix the upper hinge
to the appliance and remove the hinge itself.
Fig. 4
Take the hinge removed from the upper part of
the appliance on the opposite side (see Fig. 4)
and using the screws removed from the lower
part, fıx it to the base of the appliance itself.
Remove and refit the other hinge on the upper
part of the appliance on the opposite side. Fix
the two front screws into the upper and lower
hinges (Fig. 4).
Finally, check the alignment of the door and
make sure it closes properly. After having
reversed the opening direction of the door,
discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side.
Fig. 5
Place the appliance in the position where it is to
be built in (Fig. 5) The appliance is fitted with
adjustable feet; screw the front and rear feet in
or out to adjust the height of the appliance to
that of the recess.
Keeping the appliance central in the recess,
slide it in until its back touches the wall.
With a tape measure (or similar instrument),
measure distance (A) between the top edge of
the door and the top edge of the decorative
panel, placing it next to the recess.
Fig. 4
100-170
596
820-870
547
550
600
820
870
D506
D507
D447
D510
D467
=
=
A
Fig. 5
37
