45
Gas hob installation
The gas burner support and the relevant
hardware comes as one assembly together
with the built-in oven directly from the
factory, and it is secured onto the upper
panel of the oven to avoid damage during
transport.
Procedure
• Remove the two
fixing screws which keep
the gas burner support linked to the built-
in oven, and lift the gas burner support
upwards. Loose the screws "A" (Fig. 16)
then pull the two side brackets towards
the left and right hand side, until they
match the borders of the opening in the
worktop (Fig. 16).
Warning - To avoid that the gas
circuit tightness can be
damaged, it is essential that the
burner set is lifted up no more
that 80 mm maximum from its
original position (Fig. 17).
• Before fixing the gas burner support with
the four screws "B", check that the hob
top can be correctly mounted upon the
opening and that the position of the spark
candles and thermocouples matches the
centre of the relevant holes in the hob top.
If necessary, carry out the proper
adjustments to the gas burner support
position.
• Secure the side brackets to the worktop
by means of the four wood screws which
are supplied within the accessory kit (Fig.
17, letter "B"). Then tighten the four
adjustment screws "A".
Important - Before installing the
hob, check the it is essential that
a thorough leak test is carried
out on the connections of the gas
circuit: taps, internal pipes and
burner bodies.
PE
A
B
A B
FO 2190
Fig. 16
Fig. 18
Fig. 17
