Zanussi ZOP67922XU, Руководство пользователя

Страница: 25 / 36

CLEANING THE CAVITY EMBOSSMENT
The cleaning procedure removes limestone residue
from the cavity embossment after cooking with
steam.
For the function: True Fan Cooking
PLUSwe recommend to do the
cleaning procedure at least every 5 -
10 cooking cycles.
1. Put 250 ml of white vinegar into the cavity
embossment at the bottom of the oven.
Use maximum 6% vinegar without any
additives.
2. Let the vinegar dissolve the residual limestone
at the ambient temperature for 30 minutes.
3. Clean the cavity with warm water and a soft
cloth.
REMOVING THE SHELF SUPPORTS
To clean the oven, remove the shelf supports.
CAUTION! Be careful when you
remove the shelf supports.
1. Pull the front of the shelf support away from the
side wall.
2. Pull the rear end of the shelf support away from
the side wall and remove it.
2
1
Install the removed accessories in the opposite
sequence.
The retaining pins on the telescopic
runners must point to the front.
PYROLYSIS
CAUTION! Do not start the Pyrolysis if
the Plus Steam button is pressed in.
CAUTION! Remove all accessories
and removable shelf supports.
Do not start the Pyrolysis if you did not
fully close the oven door. In some
models, the display shows "C3" when
this error occurs.
WARNING! The oven becomes very
hot. There is a risk of burns.
CAUTION! If there are other
appliances installed in the same
cabinet, do not use them when the
Pyrolysis function operates. It can
cause damage to the appliance.
1. Wipe out the cavity with a wet, soft cloth.
2. Clean the inner side of the door with hot water,
so that the residues do not burn from the hot
air.
3. Set the Pyrolysis function. Refer to "Daily use"
chapter, "Oven Functions".
4. When flashes, press or to set the
pyrolysis duration:
Option Description
P1 Light cleaning. Du-
ration: 1 h.
P2 Normal cleaning.
Duration: 1 h 30
min.
Press or turn the knob for the temperature to
start the pyrolysis.
You can use the END function to delay the start of
the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set temperature, the
door locks. The display shows and the bars
of the heat indicator until the door unlocks.
To stop pyrolysis before it is completed, turn
the knob for the oven functions to the off
position.
6. When pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
7. When the oven is cool again, the door unlocks.
25