2
B
1
Hold the door trim (B) on the top edge of the door
at the two sides and push inwards to release the
clip seal. Pull the door trim to the front to remove it.
Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides out
of the supports completely.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
When the cleaning is completed, install the glass
panel and the oven door. Do the above steps in the
opposite sequence.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you install the internal glass panel in
the seats correctly.
A
REPLACING THE LAMP
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
Possible cause
Remedy
The oven does not heat up.
The oven is deactivated.
Activate the oven.
21
Содержание ZOB65301
Страница 1: ...GETTING STARTED EASY User Manual ZOB65301 EN User Manual 2 Oven FR Notice d utilisation 26 Four ...
Страница 51: ...51 ...
Страница 52: ...WWW ZANUSSI COM SHOP 867340409 A 402016 ...