Zanussi ZKI245, Руководство пользователя

Страница: 28 / 32

28
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic
closure of the door. To enable a correct opera-
tion of this device, it is necessary to screw the
counter-magnet (6) (steel disk + rubber ring)
into the inner side of the door.
Its position must correspond to the magnet (4)
on the appliance (see picture D).
If the door has to be opened from left to right,
invert the position of the plates (7), the mag-
net (4) and the plate (5) (Fig. B and E). Mount
the counter-magnet (6) and the hinges (1) as
previously described.
Recommendations regarding the construc-
tion and fitting of a base when the installa-
tion requires an integrated appliance to be
raised.
Where the appliance has been raised by
mounting onto a wooden base provided by the
installer. The material used to construct the
base should have a non slip surface, be water
repellent and if possible be one solid piece.
If it is not possible to use one solid piece, due
to the additional height required, ensure that
any additional strips of timber are glued and
screwed to the underside of the base (see Fig.
F).
4
6
5
1
2
3
7
8
E
6
4
8 D
Drill four fixing holes see Fig. G.
Position the base into the recess with its front
edge as far forward as the adjoining plinth line
will allow.
The reason for placing the base in this
position is to allow a small strip of beading
to be fitted in front of the appliance feet.
Fix the base firmly to the floor using four
appropriate countersunk screws (see Fig. H).
With the appliance installed adjust all four feet
ensuring the machine is stable, and a clear-
ance of approximately 5 mm is left between
the top of the machine and the underside of
the worktop.
A final check for stability should be carried out
with the machine on spin with a load, this will
identify the need for any further fine adjust-
ment to the feet.
A strip of beading approximately 605 mm W, x
5 mm H, x 25 mm D must be screwed down
into the base directly in front of the machine’s
feet, this will provide additional security.
If required an additional door magnet, part
number 1242394-00/3 and disc, part number
1242393-00/5 are available from spare parts.
600-605
5 X 25 X 605
Hardwood strip
5 mm x 25 mm
H
490
600-605 mm
50 mm
Front edge
Top view
95 mm
490 mm
G