Zanussi ZFT711W, Руководство пользователя

Страница: 16 / 52

• Wherever possible the back of the product
should be against a wall to avoid touching or
catching warm parts (compressor, condens-
er) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol are recyclable.
Control panel
1 2 3 4 5
1
Green Indicator Light
2
Red Indicator Light
3
Yellow Indicator Light
4
Freezer Switch
5
Temperature Regulator
Switching on
1. Allow the appliance to stand for 4 hrs after
installation.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clockwise
to a medium setting.
4. The Green Indicator Light will light up and
remain lit until the appliance is switched off
at the mains.
5. Press the Freezer Switch to activate the
fast-freeze function (Yellow Indicator Light
will illuminate) and leave to run for 4 hours
to allow the correct temperature to be
reached before placing food inside.
Yellow Indicator Light lights in the switch-
ed-on state of the Freezer Switch.
6. The Red Indicator Light will also illuminate
until the correct temperature is reached.
A few hours after starting up the Red Indi-
cator Light will go out to show that the cor-
rect temperature has been reached for the
setting chosen and will stay out to indicate
that everything is in order. It will come on if
the freezer temperature rises unduly for in-
stance, after opening the freezer door or
16
www.zanussi.com