27
Filling with rinse aid
(Rinse aid dispenser type B)
1. Open the container by turning the lid (A) anticlockwise.
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Top up with rinse aid when the rinse aid indicator light on the
control panel illuminates.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
(position 1 minimum dosage, position 6 maximum dosage).
Increase the dose if there are drops of water or lime spots on
the dishes after washing.
The dose is factory set in
position 5.
Reduce it if there are sticky
whitish streaks on the dishes.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Deactivation/activation of the inflow of
rinse aid
(The dishwasher must be switched off)
When the inflow of rinse aid has been deactivated, also
the rinse aid indicator light on the control panel is
automatically deactivated.
1. Press the On/Off push button. The indicator lights of
programme selection push buttons illuminate and in the
digital display are visible 2 horizontal lines (setting mode)
2. Press simultaneously function push buttons 2 and 3, until
the indicator lights of the function push buttons 1, 2 and 3
start flashing.
3. Press the function push button 2, the indicator lights of
function push buttons 1 and 3 turn off while the indicator
light of the push button 2 goes on flashing, the digital
display indicates the current setting.
4. To change the setting, press again the function push button
2, the digital display indicates the new setting.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off push button or wait about 60 seconds
after which the dishwasher will automatically return to
setting mode.
BR01
BR13
BR02
Inflow of rinse aid deactivated
Inflow of rinse aid activated (factory setting)
