Fixing to adjacent units
Insert the two fixing brack-
ets into the slots provided in
the top front part of the
dishwasher, as shown in
the figure.
Secure the brackets to adja-
cent units using two 3,5 x 16
screws for each bracket.
Important!
The dishwasher must be secured against tilting. There-
fore, make sure that the counter it is fitted under, is suit-
ably secured to a fixed structure (adjacent kitchen cabi-
nets, wall).
Warning!
When the dishwasher is secured to the kitchen
cabinets, be sure not to drill any holes into the
sides of the machine.
Adjusting the door balance
The door of the dishwasher is balanced when it
stands still in any position, if opened.
Fitting the decor panel may
sometimes affect this bal-
ance. In this case it will be
necessary to adjust the bal-
ance as follows:
Half-open the door and reg-
ulate the screws located on
the kick plate.
By screwing or unscrewing these screws by the same
amount, the tension of the door balancing springs is
increased or decreased respectively.
Warning!
The weight of the panel should be within the limit giv-
en in the "dimensions of the panel", otherwise balanc-
ing the door will not be possible.
Levelling
Make sure that the dishwasher door closes properly,
without any friction on the sides. Otherwise level the
machine by slightly screwing or unscrewing the two
front feet until perfect closure of the door is achieved.
Kitchen plinth adjustment
To allow full opening of the
door it may sometimes be
necessary to make a cutout
in the kitchen plinth (see
fig.).
According to dimensions
(a) and (b) taken as shown
on the figure, you will find,
on the following table, the
height (X) of the cut-out to
be made in the plinth.
The dimensions (a) and (b)
in the table are the most
frequently used for kitchen
units.
PII08GB
31
II29
II08
II13
a
b
II15
1 7 0 1 6 0 1 5 0 1 4 0 1 3 0 1 2 0 11 0 1 0 0
136 131 125 118 110 100 93 85
135 131 125 118 110 102 92 85
137 132 125 118 110 102 94 85
138 134 128 120 110 104 95 85
139 130 124 115 105 98 88
138 129 120 110 100 90
135 125 115 105 95
/
/
/
/
40
50
60
70
80
90
1 0 0
/
/
Height (a)*
Depth (
b
)*
X
X
600 mm
(minimum)
Dimensions of the
cut-out in plinth
(*) dimensions in mm
