Zanussi ZCF269, Руководство по эксплуатации и установке

Страница: 9 / 19

38
If you are still unable to solve the problem, summon the
assistance of authorised service staff.
Do not take any other steps. Incorrect procedure may
cause personal injury or lead to additional defects.
It is quite normal for the freezer to seem warm on the
outside occasionally, owing to the heat generated by the
freezing process. This heat also helps to prevent the
formation of moisture on the outside of the appliance which
could cause rust.
If the freezer has been switched off briefly, the compressor
may not start immediately when the current is re-
connected. This is quite normal.
IN THE CASE OF A POWER FAILURE OR
BREAKDOWN
The hold-over period mentioned in the "Technical
Specification" section of this book refers to an estimated
time the freezer temperature will take to rise to an
unacceptable level for keeping frozen foods.
Providing the period of power failure or breakdown does not
exceed the hold-over period there will be no risk of damage
to the frozen food, providing you do not open the lid during
this period.
If the freezer is only half full or the lid is opened this will
reduce the hold-over time.
After the breakdown period you are recommended to
check the condition of food to ensure it has not started to
thaw. Frozen food must NOT be re-frozen once it has
thawed out. The following guidelines should assist you.
Ice cream: Once thawed should be
discarded.
Fruits & Vegetables: If soft should be cooked and
used up.
Breads & Cakes: Can be re-frozen without
danger.
Shellfish: Should be refrigerated and
used up quickly.
Cooked Dishes: ie. casseroles should be
refrigerated and used up.
Large Pieces of Meat: Can be re-frozen providing
there are still ice crystals
remaining within them.
Small Joints: Should be cooked and can
then be re-frozen as cooked
dishes.
Chicken: Should also be cooked and re-
frozen as a cooked dish.
HOW TO CHANGE THE BULB
Before changing the bulb, isolate the appliance from the
electricity supply. Exert pressure to remove the light
glass as shown in the drawing. Unscrew the bulb, and
replace it with a new bulb (max. 15W). Then re-connect
the electricity supply. Extra bulbs are available from your
local Electrolux Service Centre.
IF SOMETHING DOES NOT WORK
IIFF YYO OU UR R FFR REEEEZZEER R D DO OEESS N NO OTT FFU UN NC CTTIIO ON N SSA ATTIISSFFA AC CTTO OR RIILLYY
Check the following before calling for service staff:
Defect: Check if: Possible cause: Action:
Freezer not cold Green light not on Plug not connected correctly Check plug and socket
Defect in switch or fuse Check fuse, call electrician
Power failure Wait until current returns
Green and red light on Fresh food recently placed in freezer Wait a couple of hours
Lid open too long Wait a couple of hours
Green light on, Thermostat set too warm Set thermostat colder
red light not on Lot of frost and ice formed Defrost freezer
Freezer too cold Yellow light on “Super” function active Press “Super” button out
Yellow light not on Thermostat set too cold Set thermostat warmer
Too much frost Lid does not close Lid in contact with Re-arrange goods,
formed completely goods in freezer check that lid closes correctly
Lot of moisture in the room Moisture from washing machine, Move freezer to a room with less
tumble-dryer, etc. moisture, or air regularly
Goods packed poorly Lot of moisture from goods Re-pack goods, see under “How to use”
enough