Zanussi
ZBN 722, Инструкция пользователя

Страница: 10 / 10

43
Before the appliance is connected:
1) check that the main fuse and the domestic installation
can support the load;
2) check that the power supply is properly earthed in
compliance with the current rules;
3) check the socket or the double pole switch used for
the electrical connection can be easily reached with
the appliance built in the forniture unit.
Built-in oven:
This appliance is delivered with electric supply cable
and plug. The plug is to be inserted into a suitable wall
socket. If connecting the appliance directly to the
electric system, a double pole switch must be installed
between the appliance and the electricity supply, with
a minimum gap of 3 mm. between the switch contacts
and of a type suitable for the required load in compliance
with the current rules. The earth wire must not be
interrupted by the double switch pole.
The connection cable has to be placed in order that, in
each part, it cannot reach a temperature 50 °C higher than
the room temperature. After the connection is carried out,
test the heating elements for about 3 minutes.
Suitable power supply cables are the following types,
considering the respective necessary section of cable:
H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-
F (T90), H05 BB-F.
Terminal block (Fig. 15)
The oven has an easily accessible terminal block, which is
meant to work with an electric single-phase rate of 230 V.
Built-under oven:
This appliance is supplied without connection cable. A
suitable one must be fitted, in compliance with the electric
supply rate, provided with a proper plug and able to carry
the load specified on the rating plate. It has to be a three-
wired cable, with the earth wire marked yellow-green.
The cable type must be one of the following:H07 RN-F,
H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05
BB-F. The plug has to be fitted in a proper socket.
Connection to terminal block
This appliance is provided with a 6 poles terminal block
(Fig. 16) set to operate with a 400 V three-phase electrical
supply with neutral wire.
To adapt the the terminal block to a different electrical
supply, carry out the connection as shown in Fig. 17.
The earth wire must be connected to terminal marked
. Once the connection is carried out, fit the cable into
the the cable clamp.
Electrical connection with the hob
This oven can be connected to hobs indicated on page
8. The socket for connecting the hob is located at the
top of the oven cabinet. The hobs come complete with
connecting leads for the hot plates/heat areas and
ground cable; these leads feature plug-in connectors.
Connection of the hob to the oven is carried out by
plugging-in these connectors to the corresponding oven
socket.
The plug-to-socket connection design is such as to
prevent possible wrong plugging-ins.
FO 2159
Fig. 15
FO 0584
Fig. 17
FO 0330
Fig. 16
FO 0039
Fig. 14
Electrical Connection
230V 3~
1 2 3 4 5
L1 L2 L3 PE
230V 1~
1 2 3 4 5
L1 N PE
400V 2N~
1 2 3 4 5
L1 L2 N PE
400V 3N~
1 2 3 4 5
L1 L2 L3 N PE
The manufacturer disclaims any
responsability should all the safety
measures not be carried out.