35
Fig. 3
The manufacturer declines all responsibility if
the accident prevention regulations are not
respected.
Fig. 4
To open the terminal box and reach the terminals
proceed as described below:
-
insert the point of a screwdriver into the visible
protruding part of the terminal box;
-
exert a light pressure and lift (fig. 4).
REPLACEMENT OF THE VOLTAGE CABLE
The connection of the voltage cable to the appliance’s terminal box is of type “Y” which signifies that its
replacement requires the specific equipment of a technician. If the replacement of the cable is necessary, use
only cables type H 05 VV H2-F O T 105; in both cases, the cables must be of sections suitable to the voltage
and able to support the working heat. Furthermore it is necessary that the yellow/green earth wire be
approximately 2 cm longer than the phase wires (fig.3). After connection try out the heating elements by
allowing them to function for about three minutes.
This appliance conforms to Directive EEC N. 87/
308 of 2.6.87 relating to the abolition of radio
interference.
FO 0287
FO 0073
Neutral
Earth wire (yellow - green)
