8
GENERAL FEATURES
The oven is furnished completely clean;
it is advisable, however, upon first use,
to turn the oven on to the maximum tem-
perature (position 10) to eliminate possi-
ble traces of grease from the oven bur-
ner. The same operation should be fol-
lowed for grill burner.
The gas oven is provided with two bur-
ners:
a) Oven burner, mounted on the lower
part of the oven (wattage: 6,20 kW)
b) Grill burner, mounted on the upper
part of the oven (wattage: 4,65 kW).
OVEN BURNER
It carries out normal “oven cooking”.
The gas flow to the burner is regulated
by a thermostat which allow to maintain
the oven temperature constant.
The control of the temperature is assu-
red by a thermostatic probe positioned
inside the oven.
The probe must be always kept in its
housing, in a clean condition, as an
incorrect position or encrustment may
cause an alteration in the control of the
temperature.
4 - GAS OVEN
The glass on the oven door rea-
ches high temperatures during
operation.
Keep children away.
The cooker lid must be kept
open when the gas oven is in
use.
IGNITION OF THE OVEN BURNER
1 – Open the oven door to the full
extent.
WARNING: Risk of explosion! The
oven door must be open during this
operation.
2 – Light the oven burner by applying a
flame to the hole ‘A’, as shown in fig.
4.2.
ATTENTION: Never turn the thermo-
stat before approaching a flame to
the hole “A” of the floor of the oven.
3 – Press in the oven control knob (fig.
4.1) and turn counter-clockwise to
position 10. Keep the knob pressed.
Never continue this operation for
more than 15 seconds. If the burn-
er has still not ignited, wait for
about 1 minute prior to repeating
the ignition.
4 – After lighting the burner, wait a few
seconds before releasing the knob
(until the safety valve stays open).
5 – Gently close the oven door and set
the oven control knob to the required
temperature.
If the flame extinguishes for any reason,
the safety valve will automatically shut
off the gas supply to the burner.
To re-light the burner, first turn the oven
control knob to position
●
, wait for at
least 1 minute and then repeat the
lighting procedure.
