Zanussi FI 4590 T, Инструкция пользователя

Страница: 9 / 10

9
MAINTENANCE
Unplug the appliance before carrying out any
maintenance operation.
Periodic cleaning
Clean the inside with warm water and bicarbonate
of soda.
Periods of non-use
If you are not using the appliance for any length of
time, the following precautions should be taken:
unplug the appliance; take all food out; defrost and
clean the inside and all the accessories; leave the
door ajar so that air can circulate inside in order to
prevent unpleasant smells forming.
Replacing the interior light bulb
The light inside the refrigerator compartment is
easy to get at through the opening in the light
holder.
If the light does not go on when the door is open,
check that it is screwed into place properly.
If it still does not light up, change the bulb.
The rating is shown on the light bulb cover.
Fig. 13
D025
SERVICING
If a fault occurs, check the following before calling
the Servicing Department:
The light does not come on when you open the door.
Check that the bulb is powered. If the electricity
supply is OK, replace the bulb.
The compressor does not work.
Check that it is powered. Check that the thermostat
is in operative mode.
The compressor runs continuously.
The thermostat is set too high.
Traces of water on the bottom of the refrigeration
compartment.
Check that the defrosting water discharge hole is
not obstructed (Fig. 12).
If the fault persists after carrying out the above
checks, call your nearest Servicing Centre.
For quick service it is important when telephoning
to give the number of the model and the serial
number, both of which can be found on the serial
number plate inside at the bottom left of the
appliance.